[Supras] Dampener bolt torque

[Bob Shapton]

I'm only guessing here but I figure it is because the key in the crank snout 
is there only for locating the pulley and cannot withstand the stresses put 
on the pulley, so the pulley must be pressed very tightly against the 
shoulder on the crank so that interface can withstand all the applicable 
forces.

Bob

> Here I go again, questioning the smart people....But can someone
> tell me WHY the vibration dampener bolt torque value is ONE HUNDRED
> NINETY-FIVE foot pounds???? Seems like about 75 would be more than
> enough....
> 
> Bill
> '90 N/A
> _______________________________________________
> Supras mailing list
> Supras at supras.com
> http://supras.com/mailman/listinfo/supras_supras.com