[Supras] Crank snout dia. and flywheel fitment?

[Rockey Fox]

My Fidanza was a bit snug going on initially and again a couple of weeks ago. I just centered it then worked it on using an aternating cross pattern on the mounting bolts until it was seated properly.

hth,
Rockey 91T

----- Original Message ----
From: "Walker, Brian (Rich. Dist)" <Brian.Walker2 at VDOT.Virginia.gov>
To: Supras at supras.com
Sent: Tuesday, January 8, 2008 11:28:13 AM
Subject: [Supras] Crank snout dia. and flywheel fitment?


We were attempting to install a new flywheel this weekend and found
 that
the centerbore was too small. I'm going to return the piece to the
vendor as they seem to think it is correct. The dia. I'm measuring
 (dig.
caliper) is 41.0mm on the crank and 40.88 on the flywheel bore, the
stock flywheel is showing right around 41mm. I'm being told that the FW
is only for a US engine in which case I thought all 7ms were (although
many assembled in Japan)

Does anyone else have a measurement for the dia at the rear of the
crank? Evidently others have not had issues with fitment.
Thanks,
Brian




_______________________________________________
Supras mailing list
Supras at supras.com
http://supras.com/mailman/listinfo/supras_supras.com






      ____________________________________________________________________________________
Looking for last minute shopping deals?  
Find them fast with Yahoo! Search.  http://tools.search.yahoo.com/newsearch/category.php?category=shopping