[Supras] Crank snout dia. and flywheel fitment?

[Jeff Mohler]

Whos is it?  My spec was....tight.  I mean, it was snnnuuuuuuug.

And, it also has to come off for balancing.

On Jan 8, 2008 8:28 AM, Walker, Brian (Rich. Dist)
<Brian.Walker2 at vdot.virginia.gov> wrote:
> We were attempting to install a new flywheel this weekend and found that
> the centerbore was too small. I'm going to return the piece to the
> vendor as they seem to think it is correct. The dia. I'm measuring (dig.
> caliper) is 41.0mm on the crank and 40.88 on the flywheel bore, the
> stock flywheel is showing right around 41mm. I'm being told that the FW
> is only for a US engine in which case I thought all 7ms were (although
> many assembled in Japan)
>
> Does anyone else have a measurement for the dia at the rear of the
> crank? Evidently others have not had issues with fitment.
> Thanks,
> Brian
>
>
>
>
> _______________________________________________
> Supras mailing list
> Supras at supras.com
> http://supras.com/mailman/listinfo/supras_supras.com
>