[Supras] WTB: Crank pulley

[Koll]

The hose fits over a brass (or yellow zinc coated steel) union.  Over the 
hose, of course sits the clamp to keep the hose from coming off of the 
union.

This union was threaded into the block on my 87 7M-GE.  On this one, there 
is no flange for a wrench, it just looks pressed in.

  Koll

----- Original Message ----- 
From: "Dan Gyoba" <dgyoba at abstractconsulting.com>
To: "Koll" <kasimonds at qwest.net>; <supras at supras.com>
Sent: Monday, February 11, 2008 10:37 AM
Subject: Re: [Supras] WTB: Crank pulley


> On 8 Feb 2008 at 20:05, Koll wrote:
>> How the heck do you pull out the vent hose #3 (crankcase to valve
>> cover - behind the alternator) union?  My 87 Supra threaded in, but
>> this one looks press fit.  This one looks like ass (19 years of
>> blowby, etc.) and I ordered a new one with all the overpriced yota
>> parts.  So, I'd like to put it in if possible and not let $35 sit on
>> the shelf mocking me for an eternity.  :)
>
> You mean the actual fitting that the hose clamps onto, or the hose itself?
>
> Dan Gyoba
> '89 NA 456,708 kms, Turbo swap COMPLETE
> http://www.abstractconsulting.com/~dan
>
>