[Supras] Which MHG to use??

[SPOOLED91T at aol.com]

Another HG bites the dust. It was the factory one on an imported motor so  no 
biggie, but now i need to figure out which MHG to use.  I think i  remember @ 
some point someone saying that the Greddy gasket had more water  passage 
holes than the HKS, but ive never seen either of them. Also i know that  the 
thickness is a big choice, but id like to keep as much compression as  possible 
unless the 2.0mm gasket is just the one to have hands down.
 
Can anyone point me in a general direction on this matter?  Im running  an 
upgraded CT-26 made into a 60-1. Id really like to turn the boost on up from  
10psi to around 15-18ish before evenutally going to a bigger aftermarket setup  
later on. Motor is internally stock and sound. I am also installing my new ARP 
 studs this go round also!! ;-)  

Jason  Green
91 MA71 (BHG)
05 XRunner