[Supras] 89 NA Upper Ball Joint

[Jeff Mohler]

No..you need the whole arm.

On 8/8/07, Joel Watkinson (Cars) <Cars at xantheon.com> wrote:
>
> As far as I can tell, what you are getting is a complete upper control
> arm with the ball joint attached.
>
> List: is it replaceable without replacing the arm?
>
> This brings up an interesting question - do the arms have the rubber in
> them? i.e., instead of replacing bushings to get back to factory rubber
> bushings, could the arms and other parts be replaced (with rubber
> installed) to get back to factory rubber bushings?
>
> > -----Original Message-----
> > From: supras-bounces at supras.com [mailto:supras-bounces at supras.com] On
> > Behalf Of Bob
> > Sent: Wednesday, August 08, 2007 5:25 PM
> > To: 'supra'
> > Subject: [Supras] 89 NA Upper Ball Joint
> >
> > I just found the clunk in the front end of my car.
> >
> >
> >
> > The drivers side boot (and I assume the joint) is shot.
> >
> >
> >
> > The only one I can find is Beck Arnley for $280.
> >
> >
> >
> > Any other suggestions?
> >
> >
> >
> > I haven't looked at OEM yet,  I doubt it will be cheaper but how much
> > worse
> > can it be?
> >
> >
> >
> > Bob
> >
> >
> >
> >
> >
> > _______________________________________________
> > Supras mailing list
> > Supras at supras.com
> > http://supras.com/mailman/listinfo/supras_supras.com
>
> _______________________________________________
> Supras mailing list
> Supras at supras.com
> http://supras.com/mailman/listinfo/supras_supras.com
>