[Supras] Sliding ramps

[Rockey Fox]

I drilled a couple of holes in my concrete for a 1/2" bolt to drop into then ran threaded rod through a 6" 2x4 and placed one of these in front of each ramp. I haven't had to do that yet in the current shop because I haven't taken time to put the epoxy sealer down. I also have pretty long store bought plastic ramps that are several inches longer in the incline than the previous steel ones.

Rockey 91T

----- Original Message ----
From: CA Jones <cjones55555 at yahoo.com>
To: Supras Supras <supras at supras.com>
Sent: Sunday, April 22, 2007 2:31:17 PM
Subject: [Supras] Sliding ramps

I never thought to ask anyone before. I always thought
I was just not very good with ramps. What are people
doing to keep the ramps from sliding?

I have an Auto trans and would creep up to the ramp
then power up with both brake and gas. Do a little
lauch and hit the brakes when it leveled off. This was
always a little nerve racking but it got it up on the
ramps.

Chris
88T Auto


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 

_______________________________________________
Supras mailing list
Supras at supras.com
http://supras.com/mailman/listinfo/supras_supras.com






__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com