[Supras] A1 Traction Arms from HPF

[FauxZ]

The end that bolts onto the hub is custom, but not terribly complex.. it's a 
U shaped piece of steel with two holes drilled in it, and then welded onto a 
threaded stud (to screw into the rod... Then the other end is a standard 
hemispherical joint with a collar, to adapt it to the metric bolt, and some 
spacers...


----- Original Message ----- 
From: "-Rich" <rdp at ix.netcom.com>
To: "FauxZ" <fauxz at arizonagt.org>
Cc: <joe at wilmcd.com>; <supras at supras.com>
Sent: Monday, May 01, 2006 9:36 AM
Subject: Re: [Supras] A1 Traction Arms from HPF


> If you guys can just buy the center section, can you just buy the endlinks 
> or are they something custom made?
> -Rich
>
>
> FauxZ wrote:
>
>>Well i didn't actually measure mine when i put them in.  I lined it up 
>>with the stock piece and then cinched it down...  my problem was that my 
>>subframe appears to be just a little tweaked so I used some of that 
>>adjustment to square things up...  and before everyone totally wigs out, 
>>it's not cracked or noticeably damaged.. just a little off...   besides, 
>>it's been that way for 10 years now (when i bought the car) so i don't 
>>think it's going anywhere... ;)
>>
>>
>>z
>>
>>----- Original Message ----- 
>>From: <joe at wilmcd.com>
>>To: <supras at supras.com>
>>Sent: Monday, May 01, 2006 4:35 AM
>>Subject: Re: [Supras] A1 Traction Arms from HPF
>>
>>
>>
>>>Oh, I hear ya. I just don't WANT to end up paying for their mistake but I
>>>might end up doing it anyway. You would think they would have figured it
>>>out by now.
>>>
>>>Thanks for measuring it. It seems like the length of the stock piece is
>>>shorter on my 87T than on another guys 88 and your 90. Good to know.
>>>
>>>
>>>-Joe
>>>
>>>
>>
>>
>>
>>_______________________________________________
>>Supras mailing list
>>Supras at supras.com
>>http://supras.com/mailman/listinfo/supras_supras.com
>>
>>
>
>